diff --git a/README.md b/README.md
index 82506ba..2fb5a7d 100644
--- a/README.md
+++ b/README.md
@@ -144,19 +144,19 @@ These settings are optional, and are already defaulted to general network common
  * `bind_forward_address`: The overridden DNS server IP address to forward all requests for your own domain to.  Defaults to the value of `internal_gateway`, which is proper in most if not all cases.  Your BIND zone is automatically converted from your `tinc_peer_name` (i.e. `lkwco_mane_lixo` becomes `lkwco.mane.lixo`).
  * `tld`: The network-wide TLD to use.  Defaults to `lixo`.
 
-# Setup
+# Setup, Installation, and Updating
 
-#### Prerequisites:
+#### Prerequisites/Setup:
 
 1. `eth0` is the **LAN** or **WAN** interface supporting external routing, DNS, etc., and is the **bridged** interface to a router that will statically route the entire desired network subnet (i.e. x.x.0.0/21) through it.  You may also have an `eth1` (and so on, so forth) that you statically configure for your entire, wide subnet (i.e. x.x.0.0/21) if you want to use two physical adapters.  If you do have more than one interface, make sure that `internal_gateway` is set to the router IP address that can route your personal Lixonet subnets, and not your WAN gateway (unless they're the same).
 2. `tun` and `tap` are in `/etc/modules` to load at boot (https://www.cyberciti.biz/faq/linux-how-to-load-a-kernel-module-automatically-at-boot-time/) and the system has been rebooted afterwards.
 3. IPv4 forwarding is on: `sysctl -w net.ipv4.ip_forward=1`
+4. Clone this repository: `git clone <url>`
+5. `mkdir /etc/lixonet/(mesh)/`
+6. Fill out `/etc/lixonet/(mesh)lixonet.conf` (see: **Configuration options**)
+7. Supply `/etc/lixonet/(mesh)/tinc.key`
 
-#### Install:
+#### Install/Update:
 
-1. Clone this repository: `git clone <url>`
-2. `mkdir /etc/lixonet/(mesh)/`
-3. Fill out `/etc/lixonet/(mesh)lixonet.conf` (see: **Configuration options**)
-4. Supply `/etc/lixonet/(mesh)/tinc.key`
 5. On the cloned repository, run `docker build -t lixonet-ee .`
 6. Run `docker run -it -v /etc/bird:/etc/bird/ -v /etc/tinc:/etc/tinc -v /etc/bind:/etc/bind -v /etc/lixonet:/etc/lixonet -v /var/run/docker.sock:/var/run/docker.sock lixonet-ee`
\ No newline at end of file